What is a hammer cyclone? How to use a hammer cyclone

Hammer-type cyclone mill is also known as laboratory grinding mill, cyclone mill, cyclone mill, etc. It is a sample grinding instrument commonly used in the laboratory. In food quality testing, hammer-type cyclone mills are often used to quickly and efficiently smash wheat, corn, rice, mung beans, soybeans, and other items. The comminuted samples meet the requirements for pre-processing of aged grains and wheat gluten. The following briefly describes the characteristics and use of hammer-type cyclone mill.

First, the hammer mill was named because it uses the high-speed cyclone principle. The sample is slowly added from the feed port, and the high-speed swirl gas flow generated by the impeller is thrown on the ring of the mill chamber and is crashed into powder. No, and sent to the sample collection bottle by the wind to obtain the desired sample. Therefore, it can be seen that the name is based on the principle and method of its work, but the use of this sample method also makes the hammer type cyclone mill has a high crushing efficiency, less sample loss, loss of protein, fat and other small content, safe and efficient Such advantages, it is very suitable for the detection of wheat, corn, rice, mung beans, soybeans and other food samples. The use of a hammer-type cyclone mill is also very simple. Just follow these steps:
1. Insert the power plug into a three-pin socket with a ground wire.
2. Press the sample holder, place the sample bottle on the seat, and check the sealing of the bottle mouth.
3. Press the switch to start the motor. If there is no abnormal operation, feed can be started.
4. Feed as evenly as possible, with a maximum feed rate of 1-2 g/s or less. The amount of feed at one time must not exceed the capacity of the model bottle. After the feeding was completed, the deposition cylinder was stopped when no material fell.
5. If it is necessary to change the model bottle while in operation, in order to prevent the material in the sample bottle from being blown out, it is possible to manually cover the inlet hopper and replace it.
6. When replacing the material to be processed, brushing should be used to clean the grinding cavity, sieve, impeller and sedimentation tube where there is residual material.
What is the above-mentioned hammer-type cyclone? How to use the hammer-type cyclone mill, if you need to know more information about agricultural instruments, please log in to the instrument channel.